Xen IPK Xen Mail CTI Installation Guide
Setting Up the System
Chapter 2 - 11
D
oc. N
o. 8557 -
Release
1.1
June 20
04
To assign phone type
Memory block 7-2 assigns port numbers and specifies the ports as Digital
Voicemail (DVM) ports.
1 Press the LK7 key.
2 Press the LK2 key.
3 Enter the port number of the first voice messaging system port.
NOTE:
Ports 01 and 02 cannot be assigned as voicemail.
4 Press the LK7 key to assign the port as DVM.
5 Press the TRANSFER key to save the port assignment and advance to
the next port.
6 Repeat steps 4 and 5 for the remaining ports.
7 Press the ANSWER key twice to exit port assignment.
CAUTION:
If you make a mistake while performing the above procedure, start
over from step 1 of the procedure, “To assign interface slot number”
on page 10.
To assign station numbers
Memory block 4-10 assigns the extension numbers that the phone system
will use to access voice messaging system ports.
1 Press the LK4 key.
2 Dial 10.
3 Press * four times, then enter the port number of the first voice
messaging extension.
4 Enter the extension number to be assigned to this port.
5 Press the TRANSFER key to save the extension number assignment.
6 Dial 10.
7 Press the CONF key to advance to the next voice messaging system
port.
8 Repeat steps 4 through 7 for each extension number to be assigned.
9 Press the ANSWER key to exit extension assignment.
