A-8
System Cabling
RAID Configuration
The RAID options available for your system is the Mylex AcceleRAID
™
150 Controller
board, which gives your system the added security of fault tolerance.
If you order a system with a RAID controller, the system is pre-cabled at the factory
(see "RAID System Cabling Configuration" figures below.)
If you are adding the AcceleRAID
™
150 Controller you must install, cable, and
configure the controller. Refer to "Installing a RAID Controller Board" in Chapter 4.
Note that Jumper JP10 (see figure below) that enables the SCSI Interrupt Steering
Logic (SISL) control on the RAID controller must be in its off position (not jumpered),
which is its default position.
Note:
The jumper is set correctly at the factory for your system
configuration. If your system requires a jumper change, change only
the jumper setting for that condition. Otherwise, keep the jumper at
its factory setting.
AcceleRAID Jumper JP10
Содержание TM1200
