NEC TM1200, Руководство пользователя

Страница: 34 / 134

2-10 Setting Up the System
Making Connections
Refer to the previous figure (Rear Features and Controls) and connect your keyboard,
monitor, and mouse. Connect any external peripheral devices such as a printer or
modem by following the instructions included with these devices.
CAUTION
Damage to the system may result if the keyboard/mouse cable is
inserted or removed when power is applied to the system.
Inserting a telephone line connector into a LAN board RJ-45 port
may result in personal injury and equipment damage.
Setting the Line Voltage
The system contains an ATX 260 watt power supply that is switch-selectable for 115 or
230 VAC at an operating frequency of 50/60Hz. The power supply voltage selection
switch is factory set to 115Vac for systems shipped to North America; it is set to
230Vac for systems shipped in Europe. Line source voltages between 200 and 240
VAC are acceptable when the power supply input voltage is set to 230 VAC.
CAUTION
Before you plug the system power cord into an AC outlet, ensure the
input line voltage setting for the power supply is correct.
To use the system with line source voltages between 200 and 240
VAC, the line voltage selector switch on the power supply must be
set to 230. If you set the switch to the 115 VAC position, the power
supply will be damaged when you plug in your system.
If you need to change the line voltage setting, perform the following steps.
Note:
If you are setting up your system for the first time, the
power cord will not be connected to the rear panel of your system.