E – 32
Lamp Mode
This feature enables you to select two brightness mode of the lamp:
Normal and Eco modes. The lamp life can be extended up to 3000
hours by using the Eco mode.
Normal ........................ Select this mode to increase lamp brightness.
This setting consumes maximum current from the
AC input and results in the most light output.
Eco .............................. Select this mode to extend lamp life.
This setting consumes minimum current from the
AC input and results in the least light output.
NOTE: If you have selected the Eco mode, the lamp lights in Normal mode
for 3 minutes after the rear projection display is turned on. After 3 minutes
the lamp will change to Eco mode.
Gamma Correction (Advanced mode)
Use the
or
buttons to choose “Normal” when in a lighted room and
“Natural 1&2” when in a darkened room. “Natural 1” for better flesh tone;
“Natural 2” for true reproduction of middle tones.
Each mode is recommended for :
Normal ........................ Regular picture
Natural 1 ..................... For line art such as CAD
Natural 2 ..................... For dark portions of a picture
Advanced Options (Advanced mode)
Aspect Ratio
Aspect Ratio allows you to select the best Aspect mode to display your
source image. You can also display the Aspect Ratio window by press-
ing the “Aspect” button on the remote control. (See page E-13).
When 4:3 is selected from the source (i.e. DVD player), the following
selections will display:
Allows for adjustments of image position and stability.
When you select Advanced Options in Advanced mode, the following
options are available: Aspect Ratio, Noise Reduction, Color Matrix, White
Balance, Auto Adjust, Position/Clock, Resolution, and Factory Default.
You can select three levels video noise reduction.
NOTE: The lower the Noise Reduction level, the better the image quality by way
of higher video bandwidth.
Color Matrix
NOTE: Aspect Ratio is not available for “RGB”.
Noise Reduction
When 16:9 is selected from the source (i.e. DVD player), the following
selections will display:
Normal
Zoom
Wide Zoom
Cinema
Standard
4:3 Aspect
All 4 sides
stretched
Left & Right
stretched
Left and right
stretched
Normal
Zoom
Wide Zoom
Cinema
16:9 image
displayed
in 4:3 mode
All 4 sides
stretched
Left & right
stretched
Left and right
stretched to
display the true
aspect
First select an appropriate color matrix to fit your component signal for
HDTV or SDTV. Then select an appropriate matrix type from B-Y/R-Y,
Cb/Cr or Pb/Pr.
NOTE: The Color Matrix feature is available for component video signal only.
