5-6 Setting System Board Jumpers
You may have to remove any installed expansion boards
to access the jumper (see “Removing an Expansion
Board” in this guide).
4.
Set the L2 SRAM Cache jumper on pins 1
−
2 for an
asynchronous cache module or on pins 2
−
3 for a
synchronous pipeline burst cache module.
5.
If you removed any expansion boards, replace them
(see “Replacing an Expansion Board” in this guide).
6.
Replace the system unit cover (see “Replacing the
System Unit Cover” in this guide).
7.
Reconnect the power cables and peripheral devices.
8.
Power on the system.
Run Setup to enable the secondary cache (see Chapter 4,
Setting System Parameters).
CLEARING YOUR PASSWORD
If you forgot your password, use the following procedure to
clear your current password and to set a new one.
1.
Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see “Removing the
System Unit Cover” in this guide).
