Setting System Parameters 4-23
Discard Changes & Exit
Use this option to exit Setup without recording any changes
you may have made.
Get Default Values
To load all the default Setup values in the Setup menus,
select Load ROM Default Values from the Main Menu. The
program displays this message:
ROM Default values have been loaded!
Press <space> to continue
If, during bootup, the BIOS program detects a problem in
the integrity of values stored in NVRAM, it displays these
messages:
System CMOS checksum bad - run SETUP
Press <F1> to resume, <F2> to Setup
The CMOS values have been corrupted or modified
incorrectly, perhaps by an application program that changes
data stored in CMOS.
Press
F1
to resume the boot or
F2
to run Setup with the
ROM default values already loaded into the menus. You
can make other changes before saving the values to
NVRAM.
Load Previous Values
If, during a Setup session, you change your mind about
your selections and have not yet saved the values to
NVRAM, you can restore the values you previously saved
to NVRAM.
Selecting Load Previous Values on the Exit menu updates
all the selections and displays this message:
CMOS values have been loaded!
Press <space> to continue