6-8 Setting System Board Jumpers
Clear CMOS Jumper
6.
Replace the system unit cover (see “Replacing the
System Unit Cover in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system. The system displays a system
configuration error message.
9.
Power off, unplug the system and monitor, and remove
the cover.
10.
Remove the jumper block from pins 18-20 and replace
it on pins 20-22.
11.
If you removed any expansion boards, replace them
(see “Replacing Expansion Boards” in Chapter 5).
12.
Replace the system unit cover. Reconnect the system
power cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see Chapter 4, NEC Drivers and Utilities).
Clear CMOS
Clear CMOS
18-20
Normal Operation
20-22
(Default)
13
17
21
14
18
22
Jumpers
13
17
21
14
18
22