NEC POWERMATE 5100 - SERVICE, Руководство по обслуживанию

Страница: 106 / 237

3-20 Disassembly and Reassembly
3.
Using a small, flat-blade screwdriver, carefully slip the blade under the
spring-loaded tab and gently pry up until the battery pops out of the socket.
!
CAUTION
Pry up gently on the spring-loaded tab as shown in the
following figure. The battery should pop completely out of
the socket so that you can remove and discard it properly.
4. Remove the battery and discard it in accordance with the manufacturer’s
instructions.
!
WARNING
The battery can explode if it is incorrectly replaced or
improperly discarded. Use only the same battery or an
equivalent type recommended by the manufacturer when
replacing the battery.
Lithium acts as a catalyst when exposed to water and
causes spontaneous combustion on contact. Discard used
batteries according to the manufacturer’s instructions.
Removing the Battery
A – Battery B – Tab
5.
With the positive (+) side facing up, slide the new battery into the socket and
press it into place.
6.
If necessary, slide the system board back into the chassis (see “Replacing the
System Board”).
7.
Replace the system unit cover (see “Replacing the Cover”).