2. System BIOS Setup
Express5800/GT110e-S User’s Guide
125
Chapter 3 Setup
2.
System BIOS Setup
This section describes how to configure Basic Input Output System (BIOS).
Before you install the server and add or remove optional devices, make sure you have read and understood
this section to configure properly.
2.1
Overview
SETUP is a utility to do basic hardware settings. This utility is pre-installed in the Internal Flash Memory in
the server as standard and can be run without requiring a media for boot.
In most of cases, the SETUP was configured for optimal performance before the server was shipped to you.
Therefore, in most of cases, you should not need to use the SETUP utility.
Use only when the case applies
to any of cases described in
Chapter 3 (2.4 Cases that Require Configuration
)
.
2.2
Starting SETUP Utility
Run POST following
Chapter 3 (1.1.1 POST sequence)
.
After a while, the following message will be displayed on the lower left of the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
If you press the <F2> key at this time, SETUP runs and displays the
Main
menu upon completion of POST.
(You can also press the <F2> key while the NEC logo appears to display the
Main
menu.)
