English-44
How to attach the arm
1. Attach the arm as follows.
Arms that can be attached:
Thickness of installation area: 2.0 mm to 3.2 mm
Compliance with VESA standard: 200 mm x 100 mm pitch
Tighten all of the screws securely in order to prevent them
from loosening. (However, the screws may break if
excessively tightened). The appropriate tightening torque
is 98 to 137 N•cm.
Caution: To prevent the monitor from falling:
• If the LCD monitor cannot be fixed in place while it is laid down,
carry out attachment operations using 2 people. Otherwise, the monitor
may fall, resulting in injuries.
• Before carrying out attachment operations, make sure to read the instruction
manual for the arm. To reduce harm, such as injuries resulting from the monitor
falling during an earthquake, etc., make sure to consult with the arm
manufacturer regarding the installation location, etc.
• Attachment of the arm is carried out under the responsibility of the customer.
Please note that if an accident should occur, NEC does not bear any
responsibility.
• Do not sleep in locations where it is possible that the monitor will fall during an earthquake, etc.
To prevent fires and electric shocks:
• When attaching the arm, make sure to use the screws indicated below. Using other screws may cause the
monitor to malfunction or for fires and electric shocks to occur.
M4 screws with locking spring washers (length: 14 mm)
• Even when an arm is attached to the monitor, do not use the monitor in a state where it is turned 90° or 180°.
Otherwise, heat becomes trapped inside, resulting in fires and electric shocks.
* The configuration for the arm’s
attachment area above is only a
reference.
Arm attachment area
Thickness: 2.0 mm to 3.2 mm
Screw
M4
14 mm
100 mm
100 mm
100 mm
Prohibition
Downloaded from ManualMonitor.com Manuals
