NEC MT2200, Руководство пользователя

Страница: 120 / 192

5-30
Upgrades and Options
Notice: When the SCSI drive fault LED indicates a
drive fault (steady yellow light), you can remove the
drive and swap in a replacement at any time when the
drive is not being accessed, without needing to power
down the system. However, drive manufacturers caution
against moving a drive that is still spinning because of
possible damage to the drive.
If you are swapping out a faulty SCSI drive, you can
pinpoint which drive to remove by checking the status
LEDs that occur in sets of three above each of the six
drive bays. Refer to “Status LED Indicator
Descriptions” in Chapter 2.
After you determine which drive has been flagged as
faulty, the procedure is the same to swap a drive or to
install one for the first time.
Installing or Swapping a Hard Drive
1. Observe the ESD caution and the notes listed at the
beginning of this section.
2. If locked, unlock and open the left front exterior
door.
3. Open the right front exterior door (see Figure 5-12).
4. Open the EMI metal panel by turning its two thumb
lock screws counter clockwise.
5. Grasp the handle of the hard disk’s carrier and press
down on its thumb-release button (see Figure 5-12).
6. If you are removing a faulty drive, check all the drive
LEDs to confirm which drive to remove. Refer to
“Status LED Indicator Descriptions” in Chapter 2.
Notice: Depending on the drive fault, the drive may be
still spinning when you remove it. Follow the next step
exactly when removing drives.