1. Installing Internal Optional Devices
Express5800/T110f-S User’s Guide
58
Chapter 2 Preparations
(b) If an optional RAID Controller is used
Jumper pins on motherboard (SWRAID)
Change jumper setting to 1-2 (Disabled).
Backplane for 2.5-inch Hard Disk Drive (provided with 2.5-inch models) (J7)
Change jumper setting to 2-3 (Optional RAID Controller)
Note
When installing an optional RAID Controller, start the BIOS Setup utility, select
PCI Configuration
from the
Advanced
menu, and then make sure that the
parameter of
PCI Slot xx ROM
(
xx
is PCI slot number) is set to
Enabled
.
Important Do not change the mode to hibernate when building a RAID System.
(c) Installation
For the instruction of installing the optional RAID Controller, refer to
Chapter 2 (1.11 PCI Card)
.
Important When connecting a RAID Controller, set the boot priority to 8th or higher in
the Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
(d) Removal
To remove the optional RAID Controller, reverse the installation procedure.
If you intend to use with the card removed, be sure to attach the blank cover attached to the riser card.
