NEC Express5800/120Rf-2, Руководство пользователя

Страница: 155 / 215

Upgrading Your System 4-51
10. Power on the server, start the SETUP utility, select [Boot]
→
[Hard Disk],
and set the boot priority in the submenu. This procedure is necessary
because installing an additional hard disk drive clears the current setting of
the boot priority.
IMPORTANT:
!
To add a hard disk during operation of the Global Array Manager (GAM),
click the Scan Device key after about 90 seconds have passed from the
installation of the hard disk. If you click the Scan Device key after executing
the Expand Array, the added disk appears correctly.
!
If a hard disk is added to the server operating in RAID1 by using the expand
array feature, the RAID is automatically changed to RAID0+1. (However, it is
not possible to set RAID0+1 directly by using a specific utility.)
11.
Install the front bezel.
Installing a Hard Disk Drive into the Flex Bay
This section explains the procedure for removing the floppy disk and CD-ROM
drives installed in the flex bay and then installing the seventh hard disk drive in
the bay (SCSI ID 8).
Note:
You cannot use the floppy disk or CD-ROM drive while the flex bay
contains a hard disk drive.
1. Observe the safety and ESD precautions listed under General Information
and Static Precautions at the beginning of this chapter.
2.
Perform the steps in "Preparing Your System for Upgrade" described earlier
in this chapter.
3.
Lift up the carrier handle at the bottom of the floppy disk drive. See Figure
4-57.
Figure 4-57. Lifting the Carrier Handle
4. Hold the carrier handle, and pull it out straight to remove the floppy disk and
CD-ROM drives from the flex bay. See Figure 4-58.