Field Service Guidelines 4-17
Figure 4-13 Removing the Bridge Battery and FDD/HDD Connector Board
3.
To remove the FDD/HDD connector board,
remove two screws followed by the retaining bracket
remove two stand offs
disengage the FDD/HDD board from the Main board.
Diskette Drive
Remove the Diskette Drive as follows.
Remove the two stand offs
Disconnect the ribbon cable at connector CN19 on the Main Board
Remove four screws (two from each side of the battery bay housing and
diskette assembly)
Remove and save the tape (die cut) that covers the bottom jointing edge of
the hard drive bay and the chassis assembly
Lift the Diskette Drive out of the chassis assembly
Remove the Diskette Drive from the assembly by removing four screws