NCR 7167, Руководство пользователя

Страница: 28 / 313

7167 Owner’s Manual Chapter 2: Setting Up and Using the Printer
November 2002 18
Checking for USB Support on the Host Computer
If the USB interface communications is required, the host computer must be equipped
and setup properly. If it is not, you need to install a USB interface card. With the
required hardware in place, Windows 98 (SR 2), Windows 98 USB Hot Patch, ID:
Q236934, NT 4.0 (Service Pack 3 or higher) and Windows 2000 natively support plug-
and-play USB with a built-in driver; Windows NT does not, and the NCR windows
NT USB driver needs to be installed.
IMPORTANT: You need to have internet access to download the USB drivers
from the NCR Web site://www.NCR.com
Host Configuration
Verify that the proper hardware has been installed in the host terminal.
Windows 98:
1. Open the Control Panel.
2. Click on System (Windows 98).
3. Click the Device Manager tab.
4. In the Device Manager window, scroll down the list of installed hardware devices
until you find an entry for “Universal serial bus controller.”
If this entry exists, your host computer is set up for USB operation. If this entry does
not appear:
•
Consult your computer documentation to see if USB must be enabled in the BIOS
setup.
Windows NT:
To see if your POS terminal is USB-compliant, look at the back.
•
If it has a USB connector port, your hardware is all set.
Note: Even though the host may have a USB port, Windows NT does not natively
support plug-and-play USB because it does not have a built-in driver. You will need
to load the NCR Windows NT USB driver (see “Installing the USB Printer Drivers”).
Windows 2000:
1. Open the Control Panel.
2. Click on System.
3. Click on Hardware.
4. Click the Device Manager tab.
5. In the Device Manager window, scroll down the list of installed hardware devices
until you find an entry for “Universal serial bus controller.”