NBK EPU-100-W5-R60, Инструкция по эксплуатации

Страница: 12 / 32

11
2 Overview
■RF/232C Switch, RUN/SET Switch Operation
Use the switches on the board to switch between wired and
wireless communication, and make other network settings. Use a
thin screwdriver, such as a precision screwdriver or a ballpoint pen,
to perform the switching.
RF/232C
Switch
RF: Controls the
unit via wireless
communication.
232C: Controls
the unit via wired
communication.
RUN/
SET
Switch
RUN: Puts the
unit into regular
operation mode,
enabling operation.
The switch should
be switched to
regular mode.
SET: Puts the unit
into wireless unit
search standby
state for wireless
unit registration
mode. Contact us
if communication
or operation is
interrupted after
changing the
network settings.
※ Change the switches prior to applying power. The signal
indicating the new switch status is sent only when the unit is
started.
※ Default factory settings are "RF" and "SET".
Warning
Do not wire or operate with wet hands. It may result in electric shock or
failure.
・ Never touch the other components on the PCB. This may result in a fault.
・ Do not use in places where static electricity is generated. This may result in
a fire or a fault.
Unit Top
SET RUN
232C
RF
A
B
Caution