Version 29.11.2022
HW: BOT(V43)(V54)
RL4-NAC12
P
a
g
e
20
2.5.3.
After-market front camera
To display the images from the front camera camera, the video interface also receives the
data from the vehicle CAN bus. If, due to missing CAN bus data (as not all vehicles are
compatible), the analogue power connection was previously made, the corresponding
manual input signal by
„Trig-FRONT“
wire is also required here.
For analogue connection, dont forget to set dip4 to OFF.
The green power supply output
„Reverse-Out“
can be used to power a front camera.
If Dip 1 is set to ON (of the black 8 dips), the power supply output su12V (max
3A) when the reverse gear is engaged …
and additionally 10, 15 or 20 seconds
delay after reverse gear is
disengaged for the front camera.
Note: In addition, a manual switch-over to the front camera input is possible via keypad
(short press) from any image mode. The power supply output su12V then, too (if Dip
3 is set to ON and the front camera input is selected).
