Navico SIMRAD AI50, Руководство по эксплуатации, Страница: 29 / 84

Initial Configuration 29
If you wish to configure your AI50 now, select “Yes”, then go
to section 5.3. If not, select “No”.
If you select “No” the following message will be displayed.
Figure 5.4 – Configuration warning
Press
W
to exit the configuration menu and return to Map
mode.
If you decide not to enter your MMSI at this stage, it can
be entered later from within the System setup menu,
refer to section 6.6. However, you will not be permitted to
enter any other information about your vessel until MMSI
entry has been completed.
Your AI50 will only operate as a receiver, until you have
fully completed the ship con fi guration as described in
Section 5.3.
5.3 Ship con fi guration procedure
From Map Mode, select Menu Mode, scroll down the menu
and select “System Setup”.
Scroll down to “System Setup” menu and select “Ship
Configuration”. A more detailed procedure is explained
further on in this chapter.
All values selected during this procedure will be
automatically stored in the AI50 memory once completed.
All data entered during this procedure can be edited
at any time, except the MMSI. Once this has been
entered and con fi rmed it will become locked and
shown as greyed out. Indicating that it can be
viewed, but not edited.
) )