Nautilus StairMaster ClubTrack 2100 Series, Руководство по обслуживанию

Страница: 13 / 92

ClubTrack
®
2100 Series Treadmill Service Manual
9
4.3 Inspect the motor drive belt for wear and cracking. Cracking is prevalent between the grooves on the
belt.
4.4 Inspect the rollers for wax build-up (black deposits on the rollers). Use #000 steel wool or a Scotch-
Brite
™
pad to clean the wax off the rollers.
4.5 Stand each roller on one end and rotate it. Listen for any squeaking sounds, and verify that the rollers
spin smoothly.
4.6 Vacuum the deck and inside the motor housing.
5.0 Installing the New Walk Belt
5.1 Slip the new belt over the deck. Make sure the deck’s waxed surface is on the up side and that the
arrow on the inside surface of the walk belt points in the proper direction of belt travel.
5.2 Lift the deck with the installed new walk belt and place it on the compression mounts.
5.3 Lift and slide the belt until the arrow is visible on top of the deck. Verify that it points toward the back
of the treadmill.
6.0 Attaching the Deck
6.1 Align the deck mounting holes with the compression mounts.
6.2 Install all twelve (12) deck screws and hand tighten.
6.3 Use a 10 mm socket to tighten all the screws. Put pressure on the deck next to the screw you are
tightening. Important: Do not over-tighten the deck screws.
Replacing the Walk Belt
DO NOT OVER-TIGHTEN THE DECK SCREWS. OVER-TIGHTENING
THE DECK SCREWS WILL DAMAGE THE COMPRESSION
MOUNTS
.
� � � � � � �
� � � � � � � � �
� � � � � �
�������������������������
� � � � � � �