14
Step 10 Remove Right Shroud
Tools Needed:
Phillips Head Screwdriver
10-1
Use a Phillips Head Screwdriver to remove the
Right Shroud.
Installation Procedure
Right Shroud
Step 11 Secure the Power “Brick” to the Frame
Tools Needed:
Two Wire Ties
11-1
Connect the Power Wire to the power connection on top of the Frame. (Figure a)
11-2
Secure the Power Brick to the mast using two Wire Ties as shown. (Figure B)
Power Connection
Power Wire
Wire Tie
Power Brick
Mast
Figure a
Figure B
ATTENTION:
The following steps apply to pre-wired Commercial Ellipticals only.
For non pre-wired instructions, refer to the appropriate LCD wiring
manual for the unit.
