Nautilus Hyosung MoniMax 5100T, Руководство оператора

Страница: 232 / 279

MoniMax 5100T 7. Appendix
7-
16
E.3 Cash Dispenser
Error Code Cause Handling
2000100
The Cash Dispenser Unit cassette is not
installed.
The Control Electronics checks if the
Cash Dispenser Unit cassette is in the
right position with the location sensor
(LS6), and generates an error when the
Cash Dispenser Unit is not in the correct
position.
1. Install the cassette again.
2. Check if LS6 (micro switch) is fully pressed
while the cassette is loaded.
3. Check if LS6 connector has been properly
inserted and if cable is cut.
4. Check logic related to LS6 of the Cash
Dispenser Unit board.
2000200
Cash is not enough.
This error occurs in the following cases:
1. When the number of bills is “0” after
the final payment transaction is made
2. When the low level sensor (LS5)
detects that the cassettes is at a low level
in “Low currency check enable” mode
1. Fill cash and set the number of bills.
* In “Low currency enable” mode:
2. Check if LS5 hole on the side of the cassettes
is matching with LS5 after installing the
cassette.
3. Check if the reflection plate of the LS5 sensor is
polluted in the cassette.
4. Check if LS5 sensor is polluted, cable is cut,
or the connector is wrongly inserted.
5. Check logic related to LS5 of the Cash
Dispenser Unit board.
2000300
The reject box is full.
This error occurs when the sum of
rejected bills during the transaction and
the rejected bills during the test is more
than 50 after finally executing “Cassette
Total”.
1. Execute “Cassette Total” after moving cash
from the reject box.
2000500
Cash Dispenser Unit data (country,
cassette, shutter) setting error occurs
during initialization.
1. Check Cash Dispenser Unit information.
2. Check battery back-up SRAM.
3. Check the battery.
2YY1500
Note has been detected on the return
path before the Cash Dispenser Unit
starts to operate.
YY = Return Path Sensor ;
1. Remove the jammed note on the return path.
2. Check if the sensor is polluted.
3. Check if cable is cut or the connector is wrongly
inserted.
4. Check logic related to the sensor in the Cash
Dispenser Unit board.
4000000 Receiving undefined command
4001100
Detecting CS2 Dark (Front Access
Type:Reject box is opened.)
4001400 Detecting CS4A Dark
4001500 Detecting CS2, CS4A Dark
4001800 Detecting CS4B Dark