Nautilus Hyosung MoniMax 5100T, Руководство оператора

Страница: 268 / 279

MoniMax 5100T 7. Appendix
7-
52
G.2 Wall Cutting preparation
The wall should be prepared according to the following guidelines before installing MoniMax 5100T.
1) The maximum thickness of wall that enables you to install this machine should not be exceeded
250mm (10 inch).
2) The height of this machine indicated on the plan is minimum height, it can be adjusted up to 30mm
(1.18 inch). (Only for Adjustor Type)
3) The installation of this machine is based on the floor from customer’s foot of outside building.
4) After installation this machine, the gap between collar and wall will be waterproofed by using of
silicon.
5) “The minimum maintenance space” should be secured in the rear of this machine.
6) All the measurements shown on the plan, ±5mm (0.2 inch) tolerance should be kept.
Note : All the unit in the dimension is millimeter and [ ] is inch scale.
Fig. 7.5 (a) Wall construction plan (Adjustor Type) Fig. 7.5 (b) Wall construction plan (Non Adjustor Type)