Nautel NX50, Руководство по установке

Страница: 54 / 74

NX50 Installation Manual Commissioning tasks
Page 9-4 Issue 6.1 2021-07-13
7. Verify the
AM Source
is set to
Unused
in the AUI’s
Presets
page’s
Analog Settings
tab.
8. Press
RF On
. The
RF On
button will turn green.
9. Check the output of the +48 V power supply on the AUI (
Meters
,
Rack 1
).
10. If you wish to remotely control the transmitter via a network or directly through a
laptop, use the AUI to configure your network parameters. See “Setting up the
Network” on page 2-78 of the NX50 Operations and Maintenance Manual for detailed
information.
NOTE
: If you are not using a network, set
DHCP
to
DISABLE
and manually set the IP
address to 0.0.0.0. This disables the “Host Network Down” alarm.
11. Check for alarms using the
Transmitter Status
page of the AUI.
12. Increase the power to the desired setpoint (use the method in Step 6 ) while monitoring
the PA voltage. Ensure the PA voltage remains within ±10% of the following
calculated value:
13. Check the reflected power level. It should be near 0 W.
14. Check for alarms using the
Transmitter Status
page of the AUI.
15. Set up your desired presets using the
Presets
page, noting you can create up to 62
presets. See the “Operating the Transmitter” section of the NX50 Operations &
Maintenance Manual for detailed information.
16. Set the time and date on the AUI display. See the NX50 Operations and Maintenance
Manual .
17. Using a web browser go to ftp://www3.nautel.com/NX_Series/ to make sure your
software version is the latest available. Check the existing software version using the
AUI’s
System Settings
->
Upgrade Software
page. If necessary, update your software.
See the “Standard Maintenance” section of the NX50 Operations & Maintenance
Manual for detailed information.