natus Dantec Keypoint Focus, Инструкции по эксплуатации оборудования

Страница: 15 / 44

Dantec Keypoint Focus
15
Cable Connections
Before operating the device, the system parts need to be connected. Follow the steps 1-3
below.
1. Connect all the signal interface cables (USB / HS-Link) as depicted in the illustrations.
2. Connect all the power interface cables as depicted in the illustrations, except the power
cord.
3. Connect the power cord to the wall outlet.
CAUTION Use only optional devices specified by Natus in order to comply with IEC 60601-
1.
CAUTION Always use shielded power line cables from Natus to avoid hum line
interference, especially near the patient, or the amplifier.
NOTE Make sure the device connected to the wall power outlet is positioned in such a way to
allow easy disconnection from the mains, if needed.
NOTE Unplugging the power line cable from the mains input on the Main Unit, disconnects
the mains power of the complete system.
NOTE HS LINK can have modules serially connected according to the following configuration
examples:
–Main Unit

(3, 6 or 8 ch) Amplifier

EP 6-ch Amplifier
–Main Unit

(3, 6 or 8 ch) Amplifier

Multi-CC stimulator
–Main Unit

(3, 6 or 8 ch) Amplifier

Focus 3-ch Amplifier
Main Unit
Connection ― Side Panel
VEP AEP
9033G0704:
9033G0701:
9033G0703:
VEP AEP LINK
CC
CC