Nature Power 23401, Инструкция по эксплуатации

Страница: 3 / 7

Page of 7 3
PARTS LIST
Part Description
1 Lamp
2 Solar Panel (16 ft. wire)
3 Screws & Anchors
4 Mounting Bracket
5 Manual
Battery included, not a part
USE AND CARE

Do not modify the solar light in any way. Unauthorized modification may impair the function and/or safety
and could affect the life of the equipment. There are specific applications for which the solar light was
designed.

Always check for damaged or worn out parts before using the solar light. Broken parts will affect the solar
light operation. Replace or repair damaged or worn parts immediately.

Store idle solar light. When solar light is not in use, store it in a secure place out of the reach of children.
Inspect it for good working condition prior to storage and before re-use.
ASSEMBLY
1. Lamp Unit Installation

Mounting your light requires a screwdriver, pencil and (in some circumstances) a power drill.

Place the mounting bracket on the surface you wish to mount to.

Mark with a pencil the position of the mounting bracket screw holes (3). This will enable you to pre-drill
your screw holes.

Once the mounting bracket is installed, ensuring all screws are tight, you are ready to position your 120
LED Ultra Bright Motion Light.

Carefully route the wire from the solar panel to the lamp and plug it into the power socket.

Adjust the motion sensor to your desired position. Your 120 LED Ultra Bright Motion Light is now
installed and ready to charge.
Note: Lamp unit should be mounted 6.5 ~ 9.8ft from the ground to ensure motion detection is optimized.
2. Solar Panel Wall or Roof Mounted Installation

Choose an area that receives the maximum amount of sunlight possible.

Use the holes located on the solar panel mounting bracket to mark the mounting surface for
installation.

Set the bracket on the surface you have chosen and secure it in place with the 3 screws and anchors
provided.

Adjust the angle of the Solar Panel to ensure it receives optimum sunlight.
Note: The Solar Panel is equipped with a 16 ft. wire. The maximum distance between the lamp unit and solar
panel can be 16 ft.