Native Instruments AUDIO KONTROL 1, Руководство по эксплуатации

Страница: 32 / 118

AUDIO KONTROL 1 – 32
5. Quickstarts
At this point, we assume that you have already physically connected your MIDI key-
board to your computer, either via USB or utlizing the AUDIO KONTROL 1’s MIDI-In
port. We also assume that you have set up your keyboard as a MIDI input device
in your operating system, so that it is available to applications using MIDI. If not,
do so before you proceed. For more information about connecting MIDI devices to
the AUDIO KONTROL 1’s MIDI ports, please read chapter 4.3.1 of this manual. If
you want to connect your MIDI keyboard directly to your computer via USB, which
is the most common method for modern keyboards, refer to the manual that came
with your MIDI keyboard.
So much for the physical part. In addition, the Mapping Application should be
running, as it loads automatically when the system starts. If this is not the case,
please refer to section 4.2 for more information. You should also have already
installed the software bundle included in AUDIO KONTROL 1. Once again, if not,
please refer to section 4.2.
Also, please make sure that you have carefully read section 3.1, which describes and
explains every socket and control found on the AUDIO KONTROL 1 hardware.
In the following you will learn how use the AUDIO KONTROL 1 for remotely control-
ling the applications delivered alongside the AUDIO KONTROL 1 software.
For more complex setups and advanced uses of AUDIO KONTROL 1, please read
the following chapter 6.