National PANTHER 5110, Инструкция по эксплуатации

Страница: 33 / 83

Page 28
5110 BLADE APPLICATION/SET-UP
THIN COATING SET-UP
Slide plate should be set high, 3'' to 6'' off the floor. Use a Cutting Head from 8" to 14" with Razor Blades
to match cutting head size.
WORKING OVER CONCRETE
Blade should be bevel up when working over concrete. Pretty much anything over concrete works. Try
different set-ups to see which works best. If goods come up difficult, slide plate should be at a low setting,
1/2" to 2" off the floor. Use a smaller size blade. If goods come up easily, slide plate can be at a high
setting and a wider blade can be used.
WORKING OVER WOOD
A heavy machine cannot be used on wood subfloors or raised panel computer floors. Keep machine light,
remove all weights. A weighted machine could break through the floor. Slide plate should be set low, 1/2"
to 2" off the floor. Blades should be as flat of an angle as possible. Use a "shoe blade", Extra Heavy Duty
Blade (these blades have a bend to them) or a regular blade, bevel up. When using a regular blade,
bending up the corners of the blade will help from the blade digging into the floor. Sometimes a shank
blade or a shank blade with a carbide tip will work. The trick on wood floors is to run the blade flat.
WORKING OVER SOFT SUB-FLOOR
Slide plate should be set low, 1/2" to 2" off the floor. Blades should be as flat of an angle as possible. Use
a "shoe blade", Extra Heavy Duty Blade (these blades have a bend to them) or a regular blade, bevel up.
When using a regular blade, bending up the corners of the blade will help from the blade digging into the
floor. Sometimes a shank blade or a shank blade with a carbide tip will work.
CAUTION: Blades are sharp, use extreme caution.
CAUTION: Never change cutting head or service
blades while machine is running.
WARNING: Disarm machine when machine is not in
use. Remove the cutting head or drop cutting head to the
floor. Failure to do so could cause severe bodily injury.
Note: When removing carpet from over VCT Tile and the tile needs to be saved, run the machine at a
45° angle over the tile. This should help to save the tile.