![background image](http://html2.mh-extra.com/html/national-instruments/vision-177-series/vision-177-series_user-manual_4808433015.webp)
Chapter 1
Hardware Overview and Installation
©
National Instruments Corporation
1-3
NI 177x Smart Camera User Manual
Connect the Power Supply and I/O
National Instruments provides the following two cable options for
connecting a power supply (782032-01) and I/O to the NI 177x Smart
Camera.
•
Power and I/O Accessory (781993-01)
—A terminal block that
simplifies power and I/O signal configuration for the NI 177x Smart
Camera. The accessory uses a 25-pin D-SUB connector and a 17-pin
M12 to 25-pin D-SUB cable.
•
17-pin M12 Pigtail Cable (153131-03)
—An open-ended cable that
you can use to create your own custom cable. Refer to the
section of Chapter 3,
Caution
Use the NI 177x Smart Camera only with a 12 W, 24 VDC ±10%, UL listed,
limited power source (LPS) supply. The power supply will bear the UL listed mark, LPS.
The power supply must also meet any safety and compliance requirements for the country
of use.
To connect a power supply to the NI 177x Smart Camera using the Power
and I/O Accessory for NI 177x Smart Cameras, refer to Figure 1-2 and
complete the following steps.