©
National Instruments Corporation
9
TBX-1329 Installation Guide
Refer to your SCXI module user manual for examples of how to connect to
field signals and loads. The functional earth terminals are connected to the
SCXI chassis through the cable shield. This is not shown in your SCXI
module user manual. Allow your signal wires to exit through the TBX-1329
cover opening.
The signal connection is now complete.
Installing the Cable and Terminal Block
Perform the following steps to mount the SH32-32-A cable assembly and
connect the TBX-1329 to your SCXI module. Refer to Figures 3 through 5
as needed.
1.
Turn off your SCXI chassis.
2.
Turn off the computer that contains your data acquisition (DAQ)
device or disconnect the device from your SCXI chassis.
3.
Connect the TBX cable adapter to the appropriate SCXI module and
secure it by tightening both thumb screws.
4.
Verify that the four backshell mounting ears on the cable assembly are
in the position shown in Figure 3 and Figure 4. If not, remove the
backshell mounting ears and install them in the position shown.