TBX-1329 Installation Guide
8
ni.com
2.
Prepare your signal wire by stripping the insulation no more
than 7 mm.
3.
Connect the signal wires to the screw terminals by inserting the
stripped end of the wire fully into the terminals.
4.
Tighten the terminals to a torque of 5-7 in.-lb (56-79 Newton cm).
5.
Relieve strain on your signal wires by tie-wrapping them to the
mounting rails of your rack.
6.
Replace the TBX-1329 terminal block cover and tighten the captive
cover screws.
Figure 2.
TBX-1329 Parts Locator Diagram
1
Safety Ground Lugs
2
Captive Cover Screws
3
Terminal Block Connector
4
Signal Wire Entry
2
1
4
3
2