National Instruments SCXI-1194, Руководство по началу работы

Страница: 5 / 23

Installing the Hardware
You must install the software before installing the hardware.
Before you install the hardware, refer to the guidelines in the
Maintain Forced-Air Cooling
Note to Users included with the module to ensure that the device can cool itself effectively.
This document is also available at ni.com/manuals .
Caution
NI SCXI switch modules are sensitive instruments that should be handled
carefully. To prevent damage to the device caused by ESD or contamination, handle
the device using the edges or the metal bracket.
Caution
Clean the hardware with a soft, nonmetallic brush. Make sure that the
hardware is completely dry and free from contaminants before returning it to
service.
To select and install a switch controller, complete the following steps:
1. Verify that your switch controller supports the switch module you want to install. Refer
to the following table.
Table 1. NI Switch Controllers and Supported NI SCXI Switches
SCXI Rear
Connector
(10- or 50-
pin)
NI Switch
Module
NI Switch Controllers
NI 4021 or
NI PXI/PCI-4065
or NI 407x
NI USB NI E Series or M
Series
NI SCXI-1127 when used with
NI SCXI-1357
kit,
NI SCXI-1358
kit, or
NI SCXI-1359
kit
when used with
USB-1357 kit,
USB-1358 kit,
USB-1359 kit,
or NI
SCXI-1600
Indirect control
1
when used with
NI SCXI-1349 and
either
SH-68-68-EPM (NI
E Series or mass-
terminated
NI USB MSeries) or
SHC68-68-EPM
(NI PXI/PCI M
Series)
NI SCXI-1128
NI SCXI-1129
NI SCXI-1130
All other Modules
1
An NI E or M Series device can control these switches when cabled to any 50-pin rear connector
NI SCXI switch module in the same chassis. Alternately, you can install an NI E or M Series
device that is not PXI Express compatible in the rightmost PXI slot of
anNI PXI-1010/1011/1050/1052 chassis. Refer to
Appendix A: PXI Express Compatibility
for
more information about PXI Express compatible devices.
4 | NI Switches Getting Started Guide | ni.com