User Guide
QuickSyn Frequency Synthesizer
42 of 44
There are no hardware adjustments within QuickSyn Synthesizers.
NI Microwave Components recommends that the QuickSyn
Synthesizer is calibrated every 24 months or whenever a problem
is suspected. The specific calibration interval depends upon the
accuracy required. No periodic preventive maintenance is required.
Each QuickSyn Synthesizer is identified by three sets of numbers:
the model number (FSW-0010 is shown in this example), a
configuration-control number (CCN), and a serial number (S/N).
These numbers are located on a label affixed to the top of the
Synthesizer. The model number, CCN, serial number, and numbers
of options must be included in correspondence regarding your
Synthesizer.
Service Information
Periodic Maintenance
Product Identification
NOTE
Calibration software is available from the NI Microwave Components website
(ni-microwavecomponents.com)
Figure 42
Example of Product Identification Label
Model Number
Configuration Control Number
Serial Number
