User Guide
QuickSyn Frequency Synthesizer
37 of 44
Number of Sweeps
This entry box is used to define the number
of times a sweep is executed. To enter a number of sweeps,
highlight the entry box and enter the desired value. The up/down
arrow on the left side of the entry box can be used to increase or
decrease the value.
Continuous On/Off
When this button is selected, the indicator
will illuminate, and sweeps will continue until the red Stop List
button is selected.
Blanking On/Off
When the Blanking button is turned on, RF
output is disabled until frequency has stabilized. The indicator on
the button will illuminate when Blanking is on.
Erase List
When the Erase List button is selected, an erase-list
command is sent and prepares the Synthesizer for a new list.
Create/Edit List
This button is used to enable the Edit List dialog
box (see Figure 34).
Run List
The Run List button is used to execute a sweep per a list
that has been created in the Edit List dialog box.
Stop List
The Stop List button is used to halt a sweep running in
list mode.
List Load Progress
The List Load Progress indicator displays
the progress of the list loading after the Load Current List button
in the Edit List dialog box is selected. The Ready indicator will
illuminate when the list is loaded and ready to be executed.
Run List Point
This button is used to set the parameter in the
list for the point number specified in the Point Number entry box
located next to the Run List Point button.
Point Number
The Point Number entry box is used to specify the
point number in the list that is being created or edited in the Edit
List dialog box. To specify a value, highlight the number in the box
and enter a new value or use the up/down arrows on the left side of
the entry box.
NOTE
When exiting the List Mode panel, a reset command is issued and the Synthesizer
returns to its last saved state.
