Caution
In some NI chassis, you must ensure that the power LED
is off. For more information about chassis power behavior, refer to
the user manual for the specific chassis.
Caution
To protect both yourself and the chassis from electrical
hazards, leave the chassis off until you finish installing the
PXIe-8822/42/62.
2. Remove any panels blocking access to the system controller slot (Slot 1) in the
chassis.
3. Touch the metal part of the chassis case to discharge any static electricity that
might be on your clothes or body.
4. Remove the protective plastic covers from the four bracket-retaining screws as
shown in the following figure.
Figure 1.
Removing Protective Plastic Covers (PXIe-8862 Shown)
1
1. Protective Screw Cap (4x)
5. Make sure the injector/ejector handle is in its downward position. Align the
PXIe-8822/42/62 with the card guides on the top and bottom of the system
controller slot.
Caution
Do not raise the injector/ejector handle as you insert
the PXIe-8822/42/62. The module will not insert properly unless the
handle is in its downward position so that it does not interfere with
the injector rail on the chassis.
ni.com
4
PXIe-8822/42/62 Getting Started
