Removing the PXIe-8822/42/62 from a PXI Express
Chassis
To remove the PXIe-8822/42/62 from a PXI Express chassis, complete the following
steps.
1. Power off the chassis.
2. Remove any cables that may be attached to the controller front panel.
3. Unscrew the four bracket-retaining screws in the front panel.
4. Press the injector/ejector handle down.
5. Slide the unit out of the chassis.
Note
If the PXI Express chassis Inhibit Mode Selector Switch is not in the
Default position, any attempt to shut down the PXIe-8822/42/62 through
the push button reset or using Windows will result in the controller Power
OK LED blinking. The user must use the Remote Inhibit pin on the Remote
Inhibit and Voltage Monitoring Connector to turn off the chassis. Refer
to the PXI Express chassis user manual for details on the functionality of
the Remote Inhibit and Voltage Monitoring controls. For chassis without a
Remote Inhibit pin, turn off the chassis AC power.
BIOS Setup Utility
You can change the PXIe-8822/42/62 configuration settings in the BIOS setup
program.
Most users do not need to use the BIOS setup program, as the PXIe-8822/42/62
controller ships with default settings that work well for most configurations.
Caution
Changing BIOS settings may lead to incorrect controller
behavior and possibly an unbootable controller. If this happens, follow
the instructions for restoring default settings in the System CMOS section.
ni.com
12
PXIe-8822/42/62 Getting Started
