© National Instruments
|
3-3
NI Smart Camera Power Requirements
Caution
Use the NI 17xx Smart Camera only with a 24 VDC ±10%, UL listed,
limited power source (LPS) supply. The power supply should bear the UL listed
mark, LPS. The power supply must meet any safety and compliance requirements for
the country of use.
The NI 17xx Smart Camera uses a nominal 24 VDC power source. The device accepts power
within the range of 24 V ±10% with an additional allowance for an AC peak of +5%. Refer to
Appendix A,
, for complete power requirement specifications.
Lighting Connector
Figure 3-1 shows the lighting connector on the NI Smart Camera.
Caution
All signals on the lighting connector are outputs from the smart camera.
Do
not
connect any external voltage or current source to any pin on the lighting
connector.
Note
The NI 1712/1732 do not offer the Direct Drive lighting controller. Do
not
connect to the LED+ and LED- connectors on the NI 1712/1732.
Note
The NI 1712 does not support strobe lighting. Do
not
connect to the strobe
connectors on the NI 1712.
Figure 3-1.
NI Smart Camera Lighting Connector
Note
Additional/replacement plugs for use with the lighting connector, part
number 780260-01, are available from NI.
1
LED- Output (Absent on the NI 1712/1732)
2
LED+ Output (Absent on the NI 1712/1732)
3
Ground Output
4
5 V TTL Strobe Output (Absent on the NI 1712)
5
24 V Strobe Output (Absent on the NI 1712)
GND
5V
24V
1
2
3
4
5
Содержание NI Vision 17 Series
Страница 1: ...ISC 1752...
