FCC/DOC Radio Frequency Interference Compliance
This equipment generates and uses radio frequency energy and, if not
installed and used in strict accordance with the instructions in this manual,
may cause interference to radio and television reception. This equipment
has been tested and found to comply with the following regulatory agencies:
•
The limits for a Class A computing device, in accordance with the
specifications in Part 15 of U.S. Federal Communications Commission
(FCC) Rules. Operation is subject to the following two conditions:
–
This device may not cause harmful interference.
–
This device must accept any interference received, including
interference that may cause undesired operation.
•
The limits for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of
Communications (DOC).
These regulations are designed to provide reasonable protection against
interference from the equipment to radio and television reception in
commercial areas.
There is no guarantee that interference will not occur in a particular
installation. However, the chances of interference are much less if the
equipment is used according to this instruction manual.
If the equipment does cause interference to radio or television reception,
which can be determined by turning the equipment on and off, one or more
of the following suggestions may reduce or eliminate the problem.
•
Operate the equipment and the receiver on different branches of your
AC electrical system.
•
Move the equipment away from the receiver with which it is
interfering.
•
Relocate the equipment with respect to the receiver.
•
Reorient the receiver's antenna.
