Installation and Configuration
Chapter 2
1014/NI-488M/Motorola UNIX
2-6
© National Instruments Corp.
Configure the GPIB-1014 or GPIB-1014D
1. Configure the GPIB-1014 or GPIB-1014D board for the following setup:
•
privileged access upon power up
•
the same base address as in the file
gpib1014
.
2. Record the board settings on the configuration form in Appendix B,
Customer Communication.
Configure the GPIB-1014P or GPIB-1014DP
1. Configure the GPIB-1014P or GPIB-1014DP board for the following
setup:
•
privileged access upon power up
•
the same VMEbus base address as in the file
gpib1014
.
•
the same interrupt request and priority code as in t he file
gpib1014
.
•
the same interrupt status/ID vector as in the file
gpib1014
.
2. Record the board settings on the configuration form in Appendix B,
Customer Communication.
C. Install the GPIB-1014 Series Board
The GPIB-1014 can be installed in any unused expansion slot in your
computer. After you change the settings (if needed) and record the settings
on the configuration form in Appendix B, Customer Communication, you
are ready to install the GPIB-1014 series board.
The following steps are general installation instructions. Consult the
manual that came with your computer for specific instructions and
warnings.
1.
Halt the system by entering the command
powerdown -y
.
2.
Turn off the power to the system and unplug the power cord.
