National Instruments cRIO-9063, Руководство пользователя

Страница: 4 / 28

Connecting the cRIO-9063 to the Host Computer or Network Using
Ethernet
Complete the following steps to connect the cRIO-9063 to a host computer or
Ethernet network using the RJ-45 Gigabit Ethernet port 1. NI recommends using the
RJ-45 Gigabit Ethernet port 1 for communication with deployed systems.
1. Power on the host computer or Ethernet hub.
2. Connect the RJ-45 Gigabit Ethernet port 1 on the cRIO-9063 to the host
computer or Ethernet hub using a standard Category 5 (CAT-5) or better
shielded, twisted-pair Ethernet cable.
Caution
To prevent data loss and to maintain the integrity of your
Ethernet installation, do not use a cable longer than 100 m (328 ft).
The cRIO-9063 attempts to initiate a DHCP network connection the first time
you connect using Ethernet. The cRIO-9063 connects to the network with a
link-local IP address with the form 169.254.x.x if it is unable to initiate a DHCP
connection.
Finding the cRIO-9063 on the Network (DHCP)
Complete the following steps to find the cRIO-9063 on a network using DHCP.
1. Disable secondary network interfaces on the host computer, such as a
wireless access card on a laptop.
2. Ensure that any anti-virus and firewall software running on the host computer
allows connections to the host computer.
Note
MAX uses UDP 44525. Refer to the documentation of your
firewall software for information about configuring the firewall to
allow communication through the UDP 44525.
3. Launch MAX on the host computer.
4. Expand
Remote Systems
in the configuration tree and locate your system.
ni.com
4
cRIO-9063 Features