3.
Align the C Series module with a slot and seat it in the slot until the latches lock in place.
Removing C Series Modules
Verify that power is not connected to the I/O connector(s) on the C Series module before you
remove a module from the cRIO-9037. If the system is in a nonhazardous location, the
cRIO-9037 can be powered on when you remove modules.
Installing the Antennas
Complete the following steps to install the antennas on the cRIO-9037.
Note
NI recommends connecting both antennas for optimal wireless performance
and reliability.
2
1
1.
Screw an antenna to the primary wireless connector. Hand tighten the antenna to the
connector.
2.
Screw an antenna to the secondary wireless connector. Hand tighten the antenna to the
connector.
NI cRIO-9037 Getting Started Guide
|
© National Instruments
|
7
