Select any additional software to install. If you plan on using the cRIO-9037 with the
LabVIEW FPGA Module, you can click
Next
. Click
NI Scan Engine
if you plan on
using the cRIO-9037 without the LabVIEW FPGA Module.
Tip
You can use this wizard at anytime to install additional software.
11. Click
Next
.
12. Verify that the summary of software to install is correct.
13. Click
Next
to start the installation.
14. Click
Finish
when the installation is complete.
Connecting the cRIO-9037 to a Wireless
Network
Complete the following steps to connect the cRIO-9037 to a wireless network.
1.
Launch MAX on the host computer.
2.
Expand Remote Systems in the configuration tree and locate your system.
3.
Select your target.
Tip
MAX lists the system under the model number followed by the serial
number, such as NI-cRIO-9037-1856AAA.
4.
Click the
Network Settings
tab.
5.
Select your country.
6.
Select
Connect to a wireless network
as the Wireless Mode.
You may need to upload a certificate by clicking
Certificate Management
. Contact your
IT department for information about your network settings and configuration details.
7.
Click
Wireless Network
to add a network from the scanned list or click
Other Network
and enter settings for your network.
8.
Click
Save
.
The Wireless Adapter wlan0 section displays the search status.
9.
Click the
System Settings
tab and verify that the chassis has a wireless IP address (along
with the Ethernet IP address); if the System State reads Connected - Running, the
cRIO-9037 is connected to the wireless network.
Creating a Wireless Network with the
cRIO-9037
Complete the following steps to connect the cRIO-9037 to a wireless network.
1.
Launch MAX on the host computer.
2.
Expand Remote Systems in the configuration tree and locate your system.
14
|
ni.com
|
NI cRIO-9037 Getting Started Guide
