1.
Pass the cables through the ferrite, leaving 50 mm to 75 mm (2 in. to 3 in.) between the
ferrite and the end of the cables. The ferrite can accommodate up to two USB cables
depending on the diameter of each cable.
2.
Close the ferrite around the cables.
USB Device Port
The cRIO-9034 USB device port is intended for device configuration, application deployment,
debugging, and maintenance. For example, you can use the USB device port to install software
or driver updates during field maintenance instead of interrupting communication on the RJ-45
Ethernet ports.
Caution
Do not hot-swap USB devices while the cRIO-9034 is in a hazardous
location or connected to high voltages. If the cRIO-9034 is not in a hazardous
location, you can connect and disconnect USB devices without affecting operation.
The following table shows the pinout for the USB device port.
Description
Signal
Pin
Pinout
Pin
Signal
Description
USB data+
D+
3
1
4
2
3
2
D-
USB data-
Ground
GND
4
1
VCC
Cable power (5 V)
The following NI cable is available for the cRIO-9034.
Table 15. USB Device Port Cable
Cable
Length
Part Number
NI Locking USB Cable
1 m
157788-01
Buttons
The cRIO-9034 provides the following buttons.
14
|
ni.com
|
NI cRIO-9034 User Manual
