©
National Instruments Corporation
7
Getting Started with the NI 7831R
PXI-7831R Installation
You can install the PXI-7831R in any available peripheral slot in the PXI
or CompactPCI chassis. Complete the following instructions to install the
PXI-7831R device.
Note
You must install the software before installing the hardware. For software
installation instructions, refer to the
section.
1.
Power off and unplug the PXI or CompactPCI chassis.
2.
Make sure there are no lit LEDs on the chassis. Wait for any lit LEDs
to go out before continuing the installation.
3.
Remove the filler panel for the peripheral slot.
4.
Ground yourself using a grounding strap or by touching a grounded
object, such as the PXI or CompactPCI chassis.
5.
Insert the PXI-7831R into the slot. Use the injector/ejector handle to
fully inject the PXI-7831R into place.
6.
Screw the front panel of the PXI-7831R to the front panel mounting
rails of the chassis.
7.
Visually verify the installation. Make sure the PXI-7831R is not
touching other devices or components and that the PXI-7831R is fully
inserted into the slot.
8.
Plug in and power on the PXI or CompactPCI chassis.
PCI-7831R Installation
You can install the PCI-7831R in any available PCI expansion slot in the
computer. To achieve the best noise performance, leave as much room as
possible between the PCI-7831R and other boards.
Complete the following instructions to install the PCI-7831R.
Note
You must install the software before installing the hardware. For software
installation instructions, refer to the
section.
1.
Power off and unplug the computer.
Caution
To protect both yourself and the computer from electrical hazards, the computer
must remain off and unplugged until the PCI-7831R device is completely installed.
2.
Remove the computer cover. Make sure there are no lit LEDs on the
motherboard. Wait for any lit LEDs to go out before continuing the
installation.