National Instruments Corporation FieldPoint cFP-20 Series, Быстрый старт

Страница: 17 / 23

17 cFP-20xx Quick Start Guide
© National Instruments Corporation
D. Click C Ch ha an nn ne ell C Co on nffiig gu urra attiio on n to access the Channel Configuration dialog box, shown in
the figure at right.
Make your selections in this dialog box as follows:
1. Select the type of channel to show, then select the channel(s) that you want to
change. To select more than one channel, clear the O On ne e c ch ha an nn ne ell a att a a ttiim me e
checkbox.
2. Set the range and output values of the selected channel(s).
3. Set the deadband for data communication over the network. The deadband setting is
a percentage of the full-scale range.
4. Set attributes for selected channel(s) by selecting the attribute and entering the
desired value.
5. Send commands to the selected channel(s) by choosing a command and value and
clicking S Se en nd d .
6. Repeat this procedure for each channel you want to configure.
7. Click O OK K , or click A Ap pp pllyy to save the changes and continue to configure channels.
When you click O OK K or A Ap pp pllyy , the changes are immediately sent to the device and
saved in its nonvolatile memory.
N NO OT TE E Configuration options vary by module. The options listed here may not be
available for some modules.