National Instruments Corporation FieldPoint cFP-20 Series, Быстрый старт

Страница: 14 / 23

14 cFP-20xx Quick Start Guide
ni.com
I. Enter an IP address for the Time Server on the
Servers tab of the System Configuration dialog
box, shown in the figure at right.
The time server is a networked computer that
runs the National Instruments Time Service
installed by FieldPoint Explorer. Enter the IP
address of the PC you are using. When you finish
configuring the controller, the time has been set
and Time Server is not a required parameter. The
cFP-20
xx has an internal battery-backed clock
that provides consistent timestamps in the absence of a time server.
J. Click O OK K in the System Configuration dialog box. Click Y Ye ess when prompted to reboot the
cFP-20
xx.
When the cFP-20 xx reboots, it should appear in Remote System Explorer with the
updated IP address and comment, as shown in the following figure. If it does not appear,
select
V Viie ew w»»R Re effrre essh h or refer to the user manual.
K. Highlight the serial number and click S Se elle ec ctt . When the new host name or IP address
appears in the Comm Resource Configuration dialog box of FieldPoint Explorer, you can
configure your devices and channels.