Page 10
Natcomm
INSTALLATION FOR CORDLESS PHONE USERS
If you operate a Single Cordless Phone Base Station only, with 1 or more
handsets, then installation is very easy. See the Diagrams on pages 7-8.
1.
Unplug the Base Station Telephone Cable from the Telephone Socket.
2.
Connect this cable to the LINE OUT Port of DS2.
3.
Connecting the LINE IN port of DS2 to the telephone using a supplied cable.
Installation by a technician is not required.
4.
Arrange for a Suitable Qualified Technician to install your Door Phone in the
required location, following the Instructions supplied with the Door Phone.
MULTI SOCKET USE INSTALLATION
Installation is required by a Suitably Qualified Technician
Where you will operate cordless or corded telephones connected to more than
One telephone socket, an approved installation technician will need to fit your
DS2 direct onto your incoming telephone line, immediately ahead of your first
telephone socket, so that your telephone line connects to all of your telephone
sockets through it. See diagram on page 9.
DS2 has been designed so that it will not interfere with the normal use of your
telephone line in any way. In the event of a malfunction or power cut, your
telephone line will continue to operate.
Your DS2 unit should be fitted inside the home or office. If it is fitted outside
next to the Door Phone, then it MUST be fitted within a Water Proof enclosure.
These instructions are for suitably qualified Installation Technicians.
1)
Locate the FIRST telephone socket on the line. Fit a New Telephone
socket next to it, or alternatively replace the Existing Telephone socket
with a Double Outlet RJ type telephone socket.
Label the Original Telephone Socket - LINE IN
Label this New Telephone Socket - LINE OUT