For Reference
24
For Reference
25
Specifications
Discs played:
(1) DVD-VIDEO disc
12 cm single-sided, single-layer
12 cm single-sided, dual-layer
12cm double-sided, single-layer
8 cm single-sided, single-layer
8 cm single-sided, dual-layer
8 cm double sided, single-layer
(2) Compact disc(VIDEO CD)
12 cm disc
8 cm dis.
S-video output:
Y output level: l Vp-p (75)
C output level: 0.286 V p-p(75)
Video output level: 1 v p-p
Audio output level: 2Vp-p (1 KHz, 0dB)
Audio signal output characteristics:
DVD (linear audio):
(1) Frequency response:
20Hv-20KHz (48KHz sampling)
20Hz 20KHz (96KHz sampling)
(2) S/N ratio: >65dBb
(3) Dynamic range: 90dB
(4) Wow and flutter: below measurable level
CD audio:
(1) Frequency response: 20Hz-20KHz
(2) S/N ratio: >65ddB
(3) Dynamic range: 90dB
(4) Wow and flutter: below measurable level
Pickup:
wave length: 655nm
Laser power: CLASS1
Specifications are subject to change without notice.
Weight and dimensions are approximate.
Model
Power Source
~110-240V 50/60Hz
Power
Consumption
20W
approx.25W when set
to the standby mode either by
the power button or the remote
control unit).
Signal system: PAL/MULT/NTSC
Operating temperature range: +5 to +35 C
Operating humidity range: 5 to 90% (no condensation)
Symptom(common)
Remedy
No power.
Insert the AC power plug securely into the power outlet.
The player is automatically
set to the standby mode.
No picture.
No key operation (by the main
unit and /or the remote control
unit) is effective.
No operations can be
performed with the
remote control unit.
No rapid advance or rapid
reverse play.
Picture is distorted during
rapid advance or rapid
reverse.
No sound.
Distorted sound.
Play fails to start even when
PLAY is pressed.
Play starts but then stops
immediately.
The player is automatically set to the standby mode after
approx. 30minutes in the stop mode (auto power-off fun-
ction). turn the power on again.
Condensation has formed: wait about l to 2 hours to allow
the player to dry out.
This player cannot play a disc other than DVD, Video CD,
SVCD and CD.
The disc may be dirty and may require cleaning.
Ensure that the disc is installed with the label side up.
Ensure that the equipment is connected properly.
Ensure that the input setting for the TV is "video".
Ensure that the equipment is connected properly.
Ensure that the input setting for the TV and stereo system
are correct.
Adjust the master volume using the GUl screen for player
information
The picture will be somewhat distorted at times: this is
normal.
Some discs may have sections which prohibit rapid adv-
ance (or rapid reverse.)
Check the batteries are installed with the correct
polarities (+ and -).
The batteries are exhausted: replace them with new ones.
Point the remote control unit at the remote control sensor
and operate.
Operate the remote control unit at a distance of not more
than 7 m from the remote control sensor.
Remove the obstacles between the remote control unit
and remote control sensor.
Press POWER to set the player to the standby mode and
then back to ON.
Alternatively, press POWER to set the player to the standby
mode, disconnect the.
Power plug and then reconnect it (The player may not be
operating properly due.
To lightning, static electricity or some other external factor.)
Troubleshooting
Before requesting service for this player check the chart below for a possible cause of the
problem you are experiencing.
Some simple checks or a adjustment on your part may eliminate the problem and restore
proper operation.
Downloaded From DvDPlayer-Manual.com Nash Manuals
