22
NARVON
Lean the pin on its seat and push the push lever until it is
introduced to the tap
Note: Correctly install the components as
shown in the figure. The non-lubrication of
the cap may cause product leakage from the
tap.
7.6. Rinsing Cycle
Before starting up the machine you must run the rinse cycle
Proceed as follows:
1. Fill the tank with clean water.
2. Turn the machine on for 5 minutes in the (agitation) mode
only.
3. Turn off the machine and empty the tank by opening the
tap.
7.7. Cleaning the drip tray
The drip tray should be emptied and cleaned daily.
Note: All of the drip trays present in the machine
should be cleaned. The drip tray should be
emptied and cleaned every time the red float
installed in the grid rises into view.
Holding the drainage hose firmly, lift the tray with the grid
on top of it and pull it out.
Wash the tray and grid separately with lukewarm water.
Dry all of the components. Reposition the grid on top of the
tray. Position the drainage hose in the opening provided.
Fit the tray back in place and press down to secure it to the
machine.
7.8. Lighted lid
Maintenance of the lighted lid must be
entrusted solely to a specialized technician,
who must organize all of the operational
sequences and use suitable equipment,
in strict compliance with the applicable
regulations currently in force.
The operator is forbidden to disassemble any
lid component.
Components:
S: Cover
T: Bulb Holder
U: Bulb
V: Lid Top (upper part)
Z: Decal
X: Lid Bottom
Y: Cable with “male” Jack Plug
Fig.44
Fig.45
Fig.46
