NARGESA C2006, Руководство пользователя, Страница: 26 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 25
At this point, enter a value for the cut dimension that can be measured easily. 100 mm is a good option for
example. Then, press the button to position the gauge at the specified location.
Next, use vernier callipers or a screw gauge to check that the distance between the gauge and the cut line
marked out by the laser beam is 100 mm (or the value that was entered in the previous step).
If the measured distance is greater than the specified level, then this difference should be added to the
gauge “Zero Position”. If the distance is less than the specified level, then the difference should be
subtracted.
For example, if we have specified a cut level of 100 mm and the actual measurement is 102.4 mm, 2.4 mm
should be added to the gauge “Zero Position”. If, however the actual distance measured is 99.3 mm,
subtract 0.7 mm from the gauge “Zero Position”.
This information can then be used to correct the gauge “Zero Position”. To do so, press the button
again and when the menu window appears, press .
The window displayed is as follows: