NARGESA C2006, Руководство пользователя, Страница: 16 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 15
5.3. Feeding of the guillotine
In order to power on the machine, it is enough jus by set the Go switch in the position o Connected. Then it
will show up al abel on screen as the one below:
Picture 8. Message of activation of the machine
Right now the machine is in a StandBy mode, it happens when it is activated but in rest position awaiting
any command the user orders.
5.4. Activating the machine
Press the reset button located in the electrical panel. This reset button must be pressed each time the
machine is turned on, and after an emergency stop has been initiated by the photocell or by the emergency
stop button.
Once the shears have started up and are in Stand-by mode, they are activated following the steps below in
order to start operations.
To proceed properly press . If the power source has recently been connected, the X and Y axes need
to be synchronised by pressing .